WideFetish Forum
General Category => W I D E Talk => Topic started by: Jaybro513 on July 31, 2019, 08:55:24 am
-
Ancient Art, among other rtes, was refitted with these. Anyone here placed ‘em? Thoughts and concerns? Contemplating placing them in Navaho sandstone. They seem to work in cutler...
Also, any thoughts on ( otherwise unprotectable ) bolt protected chimneys?
-
Nobody here climbing anymore?
-
Probably not...check the mass shooting thread
-
placed one in a rock out of the way yet?
more glue squirts out that youd figure
figure a way to deal with that
or live with the smears
your fingerprints...
-
I've placed a bunch of the 8mm version but the 6mm looked too skimpy for me so I switched to the 8mm twisted leg bolt from Bolt Products.
Takes a bit of practice to get the right amount of glue in the hole but with some thin wooden shims and a container it's easy to deal with the overflow.
Then there's the issue with setup time. If it's hot I use Hilti epoxy for the long open time.
-
I've placed a bunch of the 8mm version but the 6mm looked too skimpy for me so I switched to the 8mm twisted leg bolt from Bolt Products.
Takes a bit of practice to get the right amount of glue in the hole but with some thin wooden shims and a container it's easy to deal with the overflow.
Then there's the issue with setup time. If it's hot I use Hilti epoxy for the long open time.
Titt bolts for the win. As is anything named after funbags.
That said, Wave Bolts, with their interference fit, are a good choice for very steep (horizontal) rock.
-
superb gif +1